Wired Help:
Wireless Push Button Syncing:
- Chime has 1 button / Push button has 1 pin and jumper
- Chime has 1 button / Push button has 2 switches
- Chime has 1 button / Push button has 8 switches or pins and jumpers
- Chime has 2 buttons / Push button has 8 switches or 8 pins and jumpers
- Chime has 2 switches / Push button has 1 pin and jumper
- Chime has 7 or 8 switches or 7 or 8 pins / Push button has 1 jumper
- Chime has 7 or 8 switches or pins / Push button has 8 switches or pins
Wireless Help:
Chime has 1 button / Push button has 2 switches
1. Chime: Verify the chime has a button labeled “SYNC/ RESET”.
- If the chime has a cover, remove the cover.
Push Button: Verify the push button has 2 switches.
- Use a small flat-head screwdriver to remove the push button from the mounting plate.
2. Push Button: Set switch #1 to the ON position.
- Note: Switch #2 is used for setting the chime tune. It can be in either the ON or OFF position.
3. Chime: Press and hold the “SYNC/RESET” button until a beep (1 beep) tone is heard.
4. Push Button: Press the push button within 1 minute of the chime beep tone. The chime will sound a beep-beep (2 beeps) tone after push button is pressed.
5. Press the push button to confirm the chime and push button are synced. If chime sounds, sync is complete.