Wired Help:
Wireless Push Button Syncing:
- Chime has 1 button / Push button has 1 pin and jumper
- Chime has 1 button / Push button has 2 switches
- Chime has 1 button / Push button has 8 switches or pins and jumpers
- Chime has 2 buttons / Push button has 8 switches or 8 pins and jumpers
- Chime has 2 switches / Push button has 1 pin and jumper
- Chime has 7 or 8 switches or 7 or 8 pins / Push button has 1 jumper
- Chime has 7 or 8 switches or pins / Push button has 8 switches or pins
Wireless Help:
Chime has 2 switches / Push button has 1 pin and jumper
1. Chime: Verify the chime has 2 switches.
- If the chime has a cover, remove the cover.
- If the chime is plugged in, unplug the chime and open the access door on the rear of the chime.
Push Button: Verify the push button has 1 pin and jumper.
- Use a small flat-head screwdriver to remove the push button from the mounting plate.
- Note: The jumper is used for setting the chime tune. It can be in either the ON or OFF position.
2. Chime: Set switch #1 to the ON position.
- If the chime is a plug-in chime, plug chime into wall outlet.
- Note: Switch #2 is used for setting the chime tune. It can be in either the ON or OFF position.
Push Button: Remove battery from push button and wait 30 seconds.
3. Push Button: Install battery. Press and hold the push button for 5 - 7 seconds within 1 minute of installing battery.
4. Press the push button to confirm the chime and push button are synced. If chime sounds, sync is complete.