Talk to our specialists:

Chime has 7 or 8 switches or 7 or 8 pins / Push button has 1 jumper

1. Chime: Verify the chime has 7 or 8 switches or 7 or 8 pins and jumpers.

• If the chime has a cover, remove the cover.
• If the chime is plugged in, unplug the chime and open the small door on the rear of the chime.

Push Button: Verify the push button has 1 pin and jumper.

• Use a small flat-head screwdriver to remove the push button from the mounting plate.
• Note: The jumper is used for setting the chime tune. It can be in either the ON or OFF position.

2. Chime: Depending on chime type, either:

• Set switches #1 and #2 to the ON position and switches 3 through 7 to the OFF position or...
• Place jumpers on positions #1 and #2 and remove jumpers from positions 3 through 7.
• Note: Switch #8 and jumper #8 are used for setting the chime tune. They can be in either the ON or OFF position.

Push Button: Remove battery from push button and wait 30 seconds.

3. Push Button: Install battery. Press and hold the push button for 5 - 7 seconds within 1 minute of installing battery.
4. Press the push button to confirm the chime and push button are synced. If chime sounds, sync is complete.