Wired Help:
Wireless Push Button Syncing:
- Chime has 1 button / Push button has 1 pin and jumper
- Chime has 1 button / Push button has 2 switches
- Chime has 1 button / Push button has 8 switches or pins and jumpers
- Chime has 2 buttons / Push button has 8 switches or 8 pins and jumpers
- Chime has 2 switches / Push button has 1 pin and jumper
- Chime has 7 or 8 switches or 7 or 8 pins / Push button has 1 jumper
- Chime has 7 or 8 switches or pins / Push button has 8 switches or pins
Wireless Help:
Chime has 7 or 8 switches or pins / Push button has 8 switches or pins
1. Chime: Verify the chime has 7 or 8 switches or 7 or 8 pins and jumpers.
- If the chime has a cover, remove the cover.
- If the chime is plugged in, unplug the chime and open the access door on the rear of the chime.
Push Button: Verify the push button has 2 switches.
- Use a small flat-head screwdriver to remove the push button from the mounting plate.
2. Chime: Depending on chime type, either:
- Set switches #1 and #2 to the ON position and switches 3 through 7 to the OFF position or...
- Place jumpers on positions #1 and #2 and remove jumpers from positions 3 through 7.
- Note: Switch #8 and jumper #8 are used for setting the chime tune. They can be in either the ON or OFF position.
3. Chime: If the chime is a plug-in chime, plug chime into wall outlet.
4. Push Button: Set switch #1 to the ON position.
- Note: Switch #2 is used for setting the chime tune. It can be in either the ON or OFF position.
5. Press the push button to confirm the chime and push button are synced. If chime sounds, sync is complete.